Course notes · OCN 620
19 Surface waves, Part 1
19.1 Motivation
We begin our presentation of ocean phenomena with surface waves because of their familiarity—if they are not familiar to you, then spend some time at the beach until they are. We will use surface waves to introduce some important general wave concepts, such as dispersion relation and group velocity.
Surface waves are also interesting and important in their own right. Here are some of their roles in oceanography:
- They mediate the transfer of momentum from wind to currents.
- They generate internal waves.
- They provide a means of estimating wind stress, via a satellite-borne instrument called a scatterometer.
- They provide a means of mapping ocean surface currents via radar.
Some examples of practical importance:
- Shipping: even the largest ships can be damaged by high seas.
- Coastal development: waves can destroy structures along the coastline and move massive amounts of sand.
- Recreation!
19.2 Classification
It is hard to define the term “wave” precisely, and we will not try. We note that waves can carry energy from one place to another without net bodily motion of the water (or other medium). Waves on a medium are like simple harmonic oscillators—they require a restoring force and inertia. Surface waves may be distinguished from body waves: surface waves propagate along a surface or interface, whereas body waves, such as sound, propagate through the bulk of a substance.
There are several ways that surface waves can be classified:
- by energy source:
- Wind: wind-generated waves are ubiquitous and travel long distances, across entire ocean basins.
- Earth motion; earthquake or landslide: the resulting waves are called tsunamis. The largest recorded tsunami, in Alaska, lifted water 1200 ft above sea level.
- Astronomical motion: tides.
- by dynamics:
- capillary waves: surface tension is the restoring force.
- short gravity waves (deep-water waves): gravity is the restoring force, and vertical acceleration is important—the vertical momentum balance is not hydrostatic.
- long gravity waves (shallow-water waves): gravity is the restoring force, but vertical acceleration is not important—the vertical momentum balance is hydrostatic.
- by period: (from Pond & Pickard, 1983 (PP-IDO) p210)
- 0-0.2 s: ripples
- 0.2-9 s: wind-waves (sea) (locally generated)
- 9-15 s: swell (remotely generated)
- 15-30 s: long swell or forerunners
- 0.5 min to hours: long-period waves, including infra-gravity waves (30 s to a few minutes) and tsunamis (which have periods from 10-100 minutes)
- 12 hours and up: mostly tides
19.3 Idealized wave description:
The simplest idealized wave is infinite in horizontal extent and can be represented by a single sinusoidal function of position and time. For simplicity, choose a coordinate system such that the wave is propagating in the $x$ direction. The wave field is independent of $y$. We then have the following symbols, definitions, and relationships:
surface elevation above or below the mean: typical symbols are $\eta$ or $\xi$.
period: $T$ seconds per cycle
wavelength: $L$ meters per cycle
frequency:
cycles per second: Hertz (Hz); usually $f$
radians per second: $\mathrm{s^{-1}}$; usually $\omega$ or $\sigma$.
$\omega = 2\pi/T$; $f = 1/T$; $\omega = 2\pi f$
wavenumber: radians per meter: $\mathrm{m^{-1}}$. Usual symbol is $k$ (for one-dimensional problems). $k = 2\pi/L$.
Note: wavenumber is the spatial analog of frequency; frequency is radians per unit time, wavenumber is radians per unit length.
For propagation in two dimensions (or three, when we consider sound waves and internal waves), wavenumber is a vector, $\vec{k}$, pointing in the direction of phase propagation. Wavelength cannot be a vector. $L = 2\pi/|\vec{k}|$
amplitude: maximum deviation from the mean; typical symbol is $a$ or $A$, but things like $\eta_0$ are also commonly used.
height: often $H$; twice the amplitude; in more general case of observed waves, distance from trough to crest.
significant height: mean height of highest 1/3 of the observed waves. This is roughly what a trained observer reports as the height of the seas. It is also about 4 times the standard deviation of the sea surface elevation, based on a well-sampled time series.
steepness: $H/L$. Open ocean waves break when the steepness reaches about 1/7.
phase speed: propagation speed of a crest; the symbol is usually $c$ or $c_p$ (not to be confused with the specific heat of water at constant pressure, which has the same symbol). $c = L/T = \omega/k$.
For a single, ideal train of surface waves propagating in the $x$ direction, we can then write the surface elevation as
$$ \begin{equation} \eta = A\cos(kx - \omega t). \end{equation} $$19.4 Dispersion relation
Any given type of wave has a unique relationship between frequency and wavenumber. This is called the dispersion relation for that wave. It can be expressed as $\omega = \omega(k)$ or, equivalently, as $c = c(k)$. The dispersion relation tells us how a wave propagates.
We could write a single dispersion relation for a broad range of surface waves, from capillary waves through tsunamis, but it would be complicated. It is often more useful to consider simplest limiting cases first:
Long waves, or shallow-water waves, are simplest. If the wavelength is long compared to the water depth, $D$—say, $L > 20D$—then the dispersion relation is
$$ \begin{align} \omega &= k\sqrt{gD} \\ c &= \sqrt{gD} \end{align} $$where $g = 9.8~\mathrm{m~s^{-2}}$ is the acceleration of gravity. Note that the phase speed, $c$, is constant; it does not depend on wavelength. Waves with this property are called nondispersive.
Short waves or deep-water waves, have wavelengths short compared with the depth—$L < D$ is adequate. Their dispersion relation is
$$ \begin{align} \omega &= \sqrt{gk} \\ c &= \sqrt{g/k} \end{align} $$Here $c$ is not constant, but increases as $k^{-0.5}$ or $L^{0.5}$. Suppose there are two waves of slightly different frequency and wavenumber; their crests will travel at different speeds. Hence these waves are called dispersive. One more condition is required for the short wave dispersion relation given above: the wavelength must be long enough—say, $L > 6$ cm.
Capillary waves occur in the limit of short wavelength, when surface tension becomes the dominant restoring force and gravity can be neglected. A reasonable criterion for this limit is $L < 0.5$ cm. Then the dispersion relation is
$$ \begin{align} \omega &= \sqrt{k^3\Upsilon/\rho} \\ c &= \sqrt{k\Upsilon/\rho} \end{align} $$with $\Upsilon \approx 0.0735~\mathrm{kg~s^{-2}}$ being the surface tension (force per unit length) and with the density $\rho \approx 1000~\mathrm{kg~m^{-3}}$. Note that shorter capillary waves go faster than longer ones. This is called anomalous dispersion.
For short waves in the range of about $0.5\mathrm{cm} < L < 6\mathrm{cm}$, both surface tension and gravity are important. The dispersion relation is then:
$$ \begin{align} \omega &= \sqrt{gk + k^3\Upsilon/\rho} \\ c &= \sqrt{g/k + k\Upsilon/\rho} \end{align} $$There is a minimum speed at about $L = 1.73$ cm. Verify that for large $k$ you get the pure capillary wave dispersion relation, and for small $k$ you get the “short wave” dispersion relation.
If surface tension is negligible, then the complete dispersion relation for surface gravity waves in any depth of water is
$$ \begin{equation} \omega = \sqrt{gk\tanh kD}. \end{equation} $$Verify that this goes to the proper limits for $k$ large or small compared to $D^{-1}$.
19.5 Water velocity field
For small-amplitude waves, there is no net motion of particles—they just move back and forth. Motion at the crests is in the direction of propagation, and the reverse in the troughs. In long waves, the motion is independent of depth, and the vertical component is small compared to the horizontal component. In short waves, the particle trajectories are circular, with the diameter of the circle decaying exponentially with increasing depth as $\exp(kz)$ (with $z$ positive up).
19.6 Bending of wave crests
Two more terms you should be familiar with:
refraction: the bending of wave crests (and change in direction of $\vec{k}$) due to changes in propagation speed. For example, waves approaching a beach at an angle become more nearly parallel to the beach because of the decrease in $c$ with decreasing depth.
diffraction: the bending of waves around an obstacle. For example, waves at a narrow harbor entrance fan out into the harbor as they are diffracted by the edge of the breakwater.
19.7 Group velocity
A single sinusoidal wave train carries no information or energy—it is too uniform. Energy or information transfer requires modulation of a wavetrain (as in amplitude modulation of radio waves, for example), or equivalently, the superposition of waves with differing frequencies and wavenumbers. Consider the simplest case: the sum of two waves of equal amplitude and slightly different frequency. Let the frequencies and wavenumbers be
$$ \begin{align} \omega_1 &= \omega_0 + \Delta\omega \\ \omega_2 &= \omega_0 - \Delta\omega \\ k_1 &= k_0 + \Delta k \\ k_2 &= k_0 - \Delta k. \end{align} $$The superposition of the two waves is then
$$ \begin{align} \eta &= \eta_0\left(\cos(k_1 x - \omega_1 t) + \cos(k_2 x - \omega_2 t)\right) \\ &= 2\eta_0\cos(k_0 x - \omega_0 t)\cos(\Delta kx - \Delta\omega t), \end{align} $$where we have used the trigonometric identity
$$ \begin{equation} \cos a + \cos b = 2\cos\frac{1}{2}(a + b)\cos\frac{1}{2}(a - b). \end{equation} $$Hence we get the product of a carrier with the average frequency and wavenumber, $\omega_0$ and $k_0$, times a modulation envelope with frequency and wavenumber $\Delta\omega$ and $\Delta k$. The carrier propagates at the phase speed, $c_p = \omega/k$. The modulation envelope propagates at the speed $\Delta\omega/\Delta k$. Taking the limit as the numerator and denominator go to zero—that is, as the frequency and wavenumber difference between the two component waves gets smaller and smaller—we get the group speed:
$$ \begin{equation} c_g \equiv \frac{d\omega}{dk}. \end{equation} $$Energy and information propagate at the group speed, not the phase speed. An isolated disturbance creates a patch of waves. The patch spreads or propagates at the group speed.
Returning to the limiting cases of surface waves, we have:
$$ \begin{align} \text{long waves:}\quad & c_g = c_p = \sqrt{gD} \\ \text{short waves:}\quad & c_g = 0.5c_p = 0.5\sqrt{g/k} \\ \text{capillary:}\quad & c_g = 1.5c_p = 1.5\sqrt{k\Upsilon/\rho}. \end{align} $$Hence we see that the group speed can be equal to, less than, or greater than the phase speed, depending on the dynamics of the particular wave in question. If you are travelling with a wave packet, you will see relative motion of individual wave crests toward the front of the packet if the waves are short waves, toward the back of the packet if the waves are capillary waves, and no relative motion at all if the waves are long waves. Nondispersive waves have $c_p = c_g$; individual crests travel at the same speed as the group or packet.
Notes by Eric Firing · Last updated 2010/11/04